Engraving on mantle surface on a round detail Siemens Sinumerik 840D sl

 

Engraving on the radius surface on a round detail

 

Prerequisites in the program is adapted to TRACYL execution:

Check https://cnccodinguide.blogspot.com/2019/05/drillmill-on-diametric-part-of.html

The simulation program's tool spindle is called 3

The value after TRACYL is the diameter of the part, in this case, diameter 70

The cycle should be run in G19 plane

The zero position of the cycle is changed, e.g. X is the same as Z (depth of milling), then from zero that sits in the center (differ from the pocket cycles there) X1 is cutting depth, Y position on the arc, Z is the same as usual

The simulation shows mirrored text, therefore uses mirror writing

Tool "countersink"

Finished program:

The engraving cycle